MTN 94 Spray Paint

Shake well for at least 1–2 minutes after the mixing ball starts to rattle, and give the can another shake every so often while you paint. Some paints need longer, so check the product details for any specific guidance.

High pressure cans put out a lot of paint quickly, which makes them good for filling large areas and fast work. Low pressure cans give a slower, more controlled flow for detail, outlines and fine lines. Medium pressure cans sit in between. The cap you use also makes a big difference to the width and flow of the spray.

When you've finished painting, turn the can upside down and spray for a couple of seconds until only gas comes out. This clears paint out of the valve and cap. If a cap does block, swap it for a fresh one. Used caps can be soaked in a suitable cleaner: water for water-based paint, or cap cleaner or thinners for solvent-based paint.

Shake the can well, hold it at the recommended distance (usually around 15–30cm), keep it moving and build up colour in thin layers, letting each layer dry slightly before adding the next. Heavy single coats are the most common cause of drips and runs.

Aerosols don't perform well when they're cold – the pressure drops and the paint can spit, run or take much longer to dry. Keep cans at room temperature before use and let them warm up gradually indoors, never with direct heat. Check the product details for the recommended working temperature.

Not always. A primer helps on very absorbent surfaces (bare wood, plaster, raw concrete), very smooth or shiny surfaces (gloss plastic, glass, bare metal) and on anything you want to last outdoors. Make sure the surface is clean, dry and free of grease, and always test on a small area first.

Always work in a well-ventilated area and take regular breaks in fresh air. We recommend wearing a respirator mask with filters suitable for paint vapours, plus gloves – even with low-odour or water-based paints. Read the safety information on the can before use.

Keep cans in a cool, dry place away from direct sunlight and sources of heat. Aerosols must not be exposed to temperatures above 50°C, so never leave them in a hot car. Clearing the cap after each use (turn the can upside down and spray until only gas comes out) means it's ready to go next time.

Make sure the can is completely empty, with no paint or pressure left, then recycle it wherever your local council accepts aerosols – many UK councils do. Cans that still contain paint shouldn't go in household recycling; check with your council about disposing of them safely.

No. Aerosols can't be sent by Royal Mail, so any order containing spray paint is sent by courier instead.

MTN 94 is a low-pressure can with a smooth valve and a matt finish, giving you plenty of control for detail, fades and clean lines. It has high coverage and comes in a wide range of colours, including fluorescents.

According to Montana Colors' technical data, MTN 94 is touch dry in about 10 minutes and fully dry in 24 hours. You can add another coat of 94 within about 15 minutes – three thin coats are always better than one thick one.

Montana Colors recommends a minimum air temperature of 8°C, a surface temperature between 5°C and 50°C, and humidity below 85%. Once dry, the paint is heat resistant up to 100°C.

Each can comes with a medium Pocket Cap. MTN 94 works with a wide range of MTN caps, from fine Skinny caps for detail up to Fat caps for wide fills, so you can swap caps to suit the job.

Montana Colors gives MTN 94 a product life of up to 10 years when it's stored well – somewhere dry, away from heat and direct sunlight.

MTN 94 is low pressure with a matt finish – best for control, detail and the widest colour choice. MTN Vice is high pressure with a satin finish – best for fast coverage on a budget. MTN Water Based is low pressure, matt and low odour – best for indoor, studio and craft work.